6 recalls found. |
DEFECT #1 - EQUIPMENT:MECHANICAL:JACKS
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that bumper jack hook under some conditions may not properly engagelower edge of rear bumper due to urethane covering on bumper.if improperengage- ment of hook occurs it could allow vehicle to fall during jackingoperation.(correct by replacing hook with improved bumper hook.)
DEFECT #2 - SEATS:FRONT ASSEMBLY:RECLINER
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that left hand seat back latch may fail to lock after repeatedlatchings.if this condition exists seat lock will not meet motor vehiclesafety standard no.207.(correct by installing new improved seat back latch.)
DEFECT #3 - POWER TRAIN
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that improper axle was installed in assembly, which re- sulted inwrong speedometer pinion application.(correct by installing the properspeedometer pinion gear to axle ratio.)
DEFECT #4 - POWER TRAIN:AXLE ASSEMBLY
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that incorrect axle was installed during assembly.(correct byinstalling proper axle to match other optional equipment).
DEFECT #5 - SEATS:FRONT ASSEMBLY:RECLINER
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Chrysler campaign no 095.folding front seat back fitted withself-lockinglatch which holds back of seat in upright position may not meet requirementsof federal motor vehicle safety standard no.207.purpose of latch is tominimize possibilityof injury in event of collision.(correct by makingnecessary adjustments. )
DEFECT #6 - WHEELS:RIM
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that wheel welds were inadequate, which could cause separation fromwheel disc.(cor- rect by inspecting and change wheels where necessary.)