|
|
Recalls for
1974 International Harvester 1603
|
3 recalls found.
|
DEFECT #1 - VEHICLE SPEED CONTROL:LINKAGES
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Ihc campaign no 74507.possibility that the accelerator pedal stop boltlocated below the pedal may catch the accelerator linkage and allow pedal tostick in full open position.this condition would not allow operator tocontrol engine speed.(correct by removing stop bolt and installing afabricated stop bracket). DEFECT #2 - SERVICE BRAKES, HYDRAULIC:POWER ASSIST:VACUUM:HOSES, LINES/PIPING, AND FITTINGS
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
International harvester campaign no 74508.possibility that an incorrectvacuum hose was installed in the hydraulic brake system, from the engine to thepower brake assembly.this incorrect hose may restrict vacuum flow to thepower brake assembly under panic stop situations, thereby, increasing brakingefforts.(correct by inspecting and replacing vacuum hose.) DEFECT #3 - SERVICE BRAKES, AIR:SUPPLY:HOSES, LINES/PIPING, AND FITTINGS
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
International harvester campaign no 74516.bus chassis.possibility that theair tank piping or fitting may contact body floor due to chassis or bodymanufacturer's variances.if this condition exists air line chaffing orfitting breakage could occur, resulting in air loss affecting chassis brakesystem.(correct by inspecting and relocating air piping/fitting to precludecontact with floor).