5 recalls found. |
DEFECT #1 - VISIBILITY:WINDSHIELD WIPER/WASHER
Posted on: 1979-10-12
Description
The windshield wiper may over-travel its designed sweep angle during its initial stroke with the possibility of temporary wiper immobilization.
Consequence
Corrective Action
Dealer will install a restriction fitting in the control valve at no cost to owner.
Notes
Vehicle description: trucks.system: visual; windshield wiper.consequences of defect: in the event of heavy rain conditions, theimmobilization of wipers would cause a visual obstruction which could lead to avehicle accident.
DEFECT #2 - STEERING:WHEEL AND HANDLE BAR
Posted on: 1979-10-12
Description
The hose clamp, which was installed around the steering column boot seat to keep noise and dirt from entering the cab, may loosen.
Consequence
Corrective Action
Dealer will replace the metal hose clamp without charge.
Notes
Vehicle description: truck tractors.system: steering assembly; column.consequences of defect: if this occurs, the clamp slides down the shaft andrests between the universal joint and the manual steering gear housing,resulting in increased steering effort. This could have an adverse effect onhandling and an accident could result.
DEFECT #3 - ENGINE AND ENGINE COOLING:COOLING SYSTEM:FAN
Posted on: 1979-10-12
Description
Lockwashers, used to retain the engines fan mounting bolts, may have been omitted during assembly, causing the bolts to loosen and allowing the fan to separate from its mounting hub.
Consequence
Corrective Action
Dealer will install lockwashers on the bolts.
Notes
Vehicle description: trucks equipped with caterpillar 3208 engines.system: engine cooling; fan.consequences of defect: separation of the fan from its mounting hub could cause personal injury to occupants of the vehicle and to persons outside the vehicle.
DEFECT #4 - STEERING:WHEEL AND HANDLE BAR
Posted on: 1979-10-12
Description
Some of the involved vehicles were not inspected for adequate clearance between the steering shaft and its firewall opening. Inadequate clearance could result in the steering column becoming scored or severed by the firewall sheet metal.
Consequence
Corrective Action
Dealer will inspect vehicles and, if necessary, enlarge the firewall opening to provide the minimum 3/8 inch clearance for the steering shaft. Any scored or cut shafts will be replaced without charge to owner.
Notes
Vehicle description: trucks.system: steering; steering shaft.consequences of defect: should this occur, loss of steering control and avehicle accident could result.
DEFECT #5 - ENGINE AND ENGINE COOLING:ENGINE
Posted on: 1980-06-20
Description
The bypass oil filter mounting brackets may be insufficiently welded to the radiator frame. This could allow the filter mounting bracket and oil filter to come loose, fall, and wedge themselves within the steering geometry.
Consequence
Corrective Action
Dealer will inspect and, if necessary, reweld the bracket without charge.
Notes
Vehicle description: trucks.system: structure; bypass oil filter mounting bracket.consequences of defect: loss of steering control, without prior warning, and anaccident could result.note: until the problem is corrected, a daily inspection should be made forcracks in the welds. If found, vehicle should not be operated prior to repair.