Recalls for your 1980 Hendrickson Re305

Recalls for 1980 Hendrickson Re305

RSS Feed

1 recalls found.
All Hendrickson Recalls
Sorry, could not fetch this feed! (items)

DEFECT #1 - SUSPENSION:REAR


Posted on: 1980-07-31
Description
The bolts that clamp the mor/ryde suspension beam and lower mounting plate to the axle may break as a result of misalignment of the bolts due to non-parallel surfaces of the upper beam plate and the lower bottom plate.  Another contributing factor is the absence of shear blocks to the upper spacer pad.

Consequence


Corrective Action
Manufacturer will install new mor/ryde beam assemblies, lower mounting plates, bolts, nuts and washers.

Notes
Vehicle description: buses equipped with 10 inch rear brakes and mor/rydesuspension.system: suspension; rear engine axle, mounting bolts.consequences of defect: this condition could allow the axle to shift, possiblyresulting in loss of vehicle control and an accident.note: owner is advised to inspect the vehicle weekly for cracked or brokenbolts until the condition is corrected.
A DynaWeb Designs Internet Production | Terms of Service | Privacy Policy

Disclaimer: Recallsfinder.com uses information publicly provided by the US National Highway Traffic Safety Administration (NHTSA) and is not affiliated with any manufacturer, dealer, or government agency. The information presented on this website is for informational purposes only and should not be considered as professional advice. While we strive to provide accurate and up-to-date recall information, we do not guarantee the completeness, reliability, or accuracy of the information provided. Users are encouraged to verify the information independently and consult with relevant authorities or professionals as needed. The use of recallsfinder.com is at your own risk, and we disclaim any liability for errors or omissions in the information presented on this website.