3 recalls found. |
DEFECT #1 - VEHICLE SPEED CONTROL:CABLES
Posted on: 1983-09-06
Description
Accelerator pump lever retaining pin may loosen after repeated heavy accelerator pedal applications. This could cause the throttle to become stuck in the open position.
Consequence
Corrective Action
Dealer will install a special cotter pin, to retain the accelerator pump pin, and a spring clip thrust washer on the accelerator pump link.
Notes
Vehicle description: passenger vehicles equipped with closed loop quadrajetcarburetors and police car packages.system: power train; accelerator pump lever retaining pin.consequences of defect: vehicle speed would not decrease even after theaccelerator pedal is no longer depressed. Loss of accelerator control withoutprior warning could result in an accident.note: if the failure occurs before corrective service can be performed, drivershould shift to neutral gear and apply brakes as necessary. Vehicle should bepulled out of traffic and the ignition should be turned off after a completestop.
DEFECT #2 - SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS
Posted on: 1983-10-21
Description
The master cylinder rear brake pipe, which carries brake fluid to the rear brakes, may develop a leak due to extended chafing on the air cleaner resonator bracket.
Consequence
Corrective Action
If upon inspection the dealer finds that there is inadequate clearance, the pipe will be reformed to obtain the necessary three quarter inch space. Only those pipes showing signs of wear will be replaced.
Notes
Vehicle description: passenger vehicles and light trucks equipped with 5.7liter diesel engines.system: service brakes; master cylinder, rear brake pipe.consequences of defect: brake fluid leakage will result in loss of brakingaction at the rear wheels. Loss of vehicle control and an accident couldresult, particularly in situations where minimum stopping distance is required.
DEFECT #3 - EQUIPMENT
Posted on: 2007-10-30
Description
Certain honeywell fram racing brand hp4 and hp8 oil filters that were manufactured from may 25, 2006, through september 14, 2007, and sold for use as replacement equipment for vehicles list above. The affected filters are marked with a date code a61451 through a72571 sequentially. The date code and part number appear on the filter housing. Fram racing hp4 and hp8 oil filters not bearing a date code in this range are not affected by this recall. The gasket of the oil filter becomes more pliable under high temperatures and pressures.
Consequence
This condition may cause inadequate sealing and loss of engine oil, possibly resulting in a fire.
Corrective Action
Honeywell will replace the affected oil filters free of charge. The recall began during november 2007. Owners can contact fram customer service toll-free at 1-800-890-2075.
Notes
Customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.