3 recalls found. |
DEFECT #1 - SEAT BELTS:REAR
Posted on: 1985-05-01
Description
The 12 mm spacer used on the rear seat belt anchorage bolts may affect anchor bolt load capacity and fail to comply with fmvss 210, seat belt assembly anchorages. Consequence of defect: the rear outboard seat belt anchorages may not maintain load requirements for the specified time. This failure may cause the seat belt system not to restrain the occupant in position if an accident were to occur, causing serious injuries.
Consequence
Corrective Action
Replace 12 mm anchor bolt spacer with a 5mm spacer.
Notes
Vehicle description: passenger station wagon and sportwagon. System: rear seat belt anchor bolt/fmvss 210.
DEFECT #2 - STEERING:WHEEL AND HANDLE BAR
Posted on: 1985-07-24
Description
The steering wheel could loosen due to inadequate tightening of the wheel shaft nut. Consequence of defect: loosening of the steering wheel would affect the steering control of the car and may result in an accident.
Consequence
Corrective Action
Properly torque the nut and assure that it is retained.
Notes
Vehicle description: passenger cars and wagons. System: steering wheel shaft nut:
DEFECT #3 - VEHICLE SPEED CONTROL:CABLES
Posted on: 1985-07-30
Description
A wrong cruise control accelerator cable clip was installed in the assembly. This could allow the accelerator cable to disengage from the throttle control. Consequence of defect: the disengaged accelerator cable causes the throttle to remain partially open when cruise control is in use and results in loss of acceleration control and could cause an accident.
Consequence
Corrective Action
Install new accelerator cable clip.
Notes
Vehicle description: passenger wagons with cruise control. System: cruise control clip.