Recalls for 1986 Bmw 325

DEFECT #1 - VISIBILITY:DEFROSTER/DEFOGGER SYSTEM:WINDSHIELD:HEATER CORE

Posted on: 1993-02-05
Description
The malfunction or failure of a coolant system component results in significantly increased coolant temperature and a resulting increase in system pressure.

Consequence
Vehicles operated under this increased cooling systempressure condition can suffer damage or failure of parts of the cooling systemsuch as (1) leakage from a coolant hose, (2) leakage of the radiator orexpansion tank, (3) disconnection of a hose from a pipe or a fitting, and (4)cracks in the heater core end piece resulting in coolant leakage.  In some cases,boiling coolant can contact the lower right leg of the driver resulting inburns.  Also, escaping coolant in the passenger compartment can cause vaporfogging of the interior surface of the windows, reducing driver visibility.

Corrective Action
Dealers will install a thermostatic bypass valve in the engine compartment to control coolant temperature in the heater core.  Also, a new design radiator cap will be installed, to control pressure and provide greater coolant overflow in the event of overheating.

Notes
System: coolant system.vehicle description: passenger cars.

DEFECT #2 - STEERING:WHEEL AND HANDLE BAR

Posted on: 1986-10-21
Description
The two parts of the steering column disengagement element could completely disconnect if the car contacts an object in the roadway or elsewhere of sufficient mass to apply a significant force directly to the steering gearbox.  Consequence of defect: steering control would be lost.

Consequence


Corrective Action
Bolt two specially formed plates to the disengagement element so that steering capability will be retained.

Notes
System: steering column.vehicle description: passenger cars.

DEFECT #3 - SERVICE BRAKES, HYDRAULIC:SWITCHES:BRAKE LIGHT

Posted on: 1986-11-14
Description
Brake light switch could overheat, eventually leading to melting of plastic internal parts in area of electrical contacts.

Consequence
Consequence of defect: switch plunger could jam, rendering brake lights either inoperative or continuously illiminated, regardless of brake pedal operation.

Corrective Action
Replace brake light switch with revised switch with increased electrical load capacity.

Notes
System: brake light switch.  Vehicle description: passenger cars with high brake lights.