2 recalls found. |
DEFECT #1 - SEAT BELTS:FRONT:BUCKLE ASSEMBLY
Posted on: 1995-05-24
Description
The front safety belt buckle release buttons can break. These red plastic release buttons are marked press. If a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.
Consequence
The safety belts would not provide adequate protection to an occupant in a vehicle crash.
Corrective Action
Owners should promptly check the condition and operation of both front safety belt buckles and carefully inspect the red release button for any breaks or cracks. They should ensure that both buckles are operating properly by inserting each latch plate into its buckle, tugging on the belt to make sure the latch is securely locked, and then pressing the release button. The latch plate should pop out of the buckle when the button is pressed. If either release button shows a sign of breaking or cracking or if either buckle fails to operate properly, owners should promptly contact their authorized dealer to schedule an appointment to have the buckle replaced or repaired, free of charge. The manufacturer is developing a remedy designed to prevent failure of the buttons that are not currently broken.
Notes
System: interior; seat belts; belt buckles.vehicle description: passenger vehicles and light duty trucks and vans equipped with safety belts made by takata corporation.note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided free of charge within a reasonable time, please contact mitsubishi at 1-800-222-0037. Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
DEFECT #2 - ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:MANIFOLD/HEADER/MUFFLER/TAIL PIPE
Posted on: 1988-09-23
Description
Heat shield was installed on lower side of muffler instead of the upper side.
Consequence
The heat shield assists in dissipation of heat from theupper portion of the muffler. Without the heat shield, the muffler mightcontact the trunk of the car, damaging the contents.
Corrective Action
A heat shield will be installed on the upper portion of the muffler.
Notes
System: replacement muffler, part number 7519.vehicle category: 1985-87 mitsubishi galant.note: this recall was initiated by midas international corporation.allquestions should be addressed to this corporation or its dealers.