Recalls for your 1988 Neoplan Transit Bus

Recalls for 1988 Neoplan Transit Bus

RSS Feed


2 recalls found.
All Neoplan Recalls

DEFECT #1 - ELECTRICAL SYSTEM:IGNITION:MODULE


Posted on: 1992-03-16
Description
Stray voltage induced on the power takeoff (pto) signal circuit 510 may occur when the electronic control module (ecm) connector gets wet, causing unintended engine acceleration.

Consequence
Unintended engine acceleration while the bus is in gearmay result in a loss of vehicle control and an accident.

Corrective Action
Install a ground interlock to ground circuit 510 in the ddec system anytime the pto is disabled for any reason.  The ground eliminates the stray voltage effect between the ecm connector and circuit 510.

Notes
System: electrical system.vehicle description: transit buses and inter-city coaches equipped with detroitdiesel ec-1 and ec-ii controlled 6v-92ta, 8v-92ta, and series 60 engines.

DEFECT #2 - UNKNOWN OR OTHER


Posted on: 1989-11-29
Description
Certain bolts such as the drive shaft bolts, steering mounting bolts, motor mount bolts, and the wheel chair support bolts may not meet sae specifications.

Consequence
Bolts could break or fail affecting the specific component involved, resulting in a potential an accident and/or personal injury.

Corrective Action
Replace non-specification bolts with bolts that meet sae specifications.

Notes
System: non-standard bolts.vehicle description: transit buses.