Recalls for 1991 Chevrolet T10

DEFECT #1 - SUSPENSION:FRONT:CONTROL ARM:LOWER ARM

Posted on: 1990-11-29
Description
Nuts used to attach lower control arms, rear spring and shackle, and rear shock absorbers do not meet specifications and could strip.

Consequence
Stripping of the nuts in the rear suspension could reduceclamp load on lower control arm, which could allow the arm to detach, resultingin loss of vehicle control and an accident.

Corrective Action
Replace lower control arm attachment nuts as well as rear spring and shackle, and rear shock absorber nuts.

Notes
System: lower control arm attaching nuts.vehicle description: light duty trucks

DEFECT #2 - VISIBILITY:WINDSHIELD

Posted on: 1990-06-14
Description
Use of improper primer on metal surfaces of windshield and side window openings could cause low adhesion to the metal surface and would not provide retention required by fmvss 212.

Consequence
Windshield and side window glass would not prevent theejection of vehicle occupants during a vehicle crash, which causes seriousinjuries and fatalities.

Corrective Action
Remove and reinstall glass using proper primer.

Notes
System: windshield and side window mounting; fmvss 212.vehicle description: utility, pickup, and extended cab pickup trucks.

DEFECT #3 - FUEL SYSTEM, GASOLINE:STORAGE

Posted on: 1991-07-01
Description
Vehicles have been shipped with the fuel tank sender seal out of position.

Consequence
In the event of rollover accident, an out of postionseal could allow fuel spillage in excess of the amount prescribed by fmvss 301.spilled fuel could ignite near an ignition source.

Corrective Action
Replace sender seals.

Notes
System: fuel systems; fmvss 301.vehicle description: light trucks and multi-purpose vehicles.