7 recalls found. |
DEFECT #1 - SEAT BELTS:FRONT:ANCHORAGE
Posted on: 1996-03-12
Description
The rivets holding the rear outboard belt d-rings were not heat treated properly causing the heads of the rivets to fracture under load and fail to hold the d-rings to the straps. This does not conform to the requirements of fmvss no. 210, seat belt assembly anchorages.
Consequence
Consequence of non-compliance: this condition can reduce the restraining capabilities of the safety belt in the event of an accident.
Corrective Action
Dealers will install a reinforcement plate on the rear outboard seat belt assembly anchorages involved in this campaign.
Notes
System: interior; restraint; belt anchor and attachment; fmvss no. 210.vehicle description: passenger vehicles.note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time, should contact ford at 1-800-392-3673. Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
DEFECT #2 - FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP
Posted on: 1995-03-31
Description
The seal material between the fuel filler pipe and fuel tank may not have been fully cured during the molding process which could allow for fuel leakage.
Consequence
Fuel leakage could result in a vehicle fire if an ignition source were present.
Corrective Action
Dealers will replace the fuel filler pipe-to-fuel tank seal with a new seal of different material.
Notes
System: fuel; fuel tank assembly; pipe; filler; neck.vehicle description: passenger vehicles.note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided free of charge within a reasonable time, please contact ford at 1-800-392-3673. Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
DEFECT #3 - ELECTRICAL SYSTEM:FUSES AND CIRCUIT BREAKERS
Posted on: 1995-10-04
Description
These vehicles were built with the non-cycling power window circuit breaker and the cycling headlamp circuit breaker interchanged.
Consequence
In the event of a short or overload in the headlampcircuit, both headlamps can go out without warning, rather than flashing as intended with the cycling circuit breaker. This could lead to reduced night time driver visibility, increasing the potential for a vehicle accident.
Corrective Action
Dealers will inspect these vehicles, remove the circuit breaker and reinstall the breaker in the correct locations.
Notes
System: electrical; fuse and recepticle; circuit breaker.vehicle description: passenger vehicles.note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford at 1-800-392-3673. Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
DEFECT #4 - AIR BAGS:FRONTAL
Posted on: 1995-02-28
Description
The passenger side air bag has an inflator body that cracked during forming of the curl that retains the igniter plug in the end of the inflator. Also the igniter end cap can separate from the inflator.
Consequence
The passenger side air bag may not inflate properly resulting in reduced occupant protection in a vehicle accident. If the igniter end cap separates in a frontal collision, hot gases can be released and ignite flammable material or cause burn injuries.
Corrective Action
Dealers will remove and replace the passenger side air bag module.
Notes
System: interior; passive restraints; air bag; passenger. Vehicle description: passenger side air bag in passenger cars, vans andmulti-purpose vehicles. Note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided free of charge within a reasonable time, contact ford at 1-800-392-3673. Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
DEFECT #5 - VEHICLE SPEED CONTROL:CRUISE CONTROL
Posted on: 2008-02-04
Description
Ford is recalling 225,000 my 1992-2003 econoline, my 1993-1995 taurus sho, my 1992-1998 crown victoria, my 1993 bronco, f-series, my 1995-1997 f-series super duty stripped chassis, my 1992-1998 mercury grand marquis, and my 1992-1995 lincoln town car vehicles. The affected vehicles were previously repaired using a wiring harness that is not compatible with the vehicle circuit polarity.
Consequence
As a result, the fuse is located in the output circuit rather than in the intended input power feed circuit, and may not offer the intended protection in the event of an electrical short to ground.
Corrective Action
Dealers will install a new wiring harness, or replace the mating electrical component. The recall began on february 18, 2008. Owners may contact ford at 1-800-392-3673.
Notes
Ford recall no. 08s01.customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov.
DEFECT #6 - VEHICLE SPEED CONTROL
Posted on: 2007-08-03
Description
On certain pickup trucks, passenger vehicles, sport utility vehicles, and motor homes chassis, the speed control deactivation switch may, under certain conditions, leak internally and then overheat, smoke, or burn.
Consequence
This could result in an underhood fire.
Corrective Action
Dealers will install a fused wiring harness. Owners of the passenger cars included in this campaign will be instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected as an interim repair. As soon as repair parts are available (expected october 2007), owners will be instructed to return to the dealers for installation of a fused wiring harness. The recall began on august 13, 2007, and mailing completed by september 19, 2007. Owners may contact ford at 1-888-222-2751.
Notes
Ford recall no. 05s28.customers may also contact the national highway traffic safety administration;s vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov.
DEFECT #7 - STEERING
Posted on: 2015-10-06
Description
Dorman products, inc. (dorman) is recalling certain model dorman steering shafts, part number 425-359, solutions steering shafts, part number 7-0359, and oe solutions steering shafts, part number 425-359, manufactured april 17, 2014, to september 28, 2015. These aftermarket replacement steering shafts are sold for use in 1995-2002 ford crown victoria, mercury grand marquis, and lincoln town car vehicles. These steering shafts may separate during operation if the integral fastener is loose or missing and if the interfacing vehicle shaft is compressed in length.
Consequence
If the shafts separate during vehicle operation, a loss of steering control would result, increasing the risk of a vehicle crash.
Corrective Action
Dorman will notify owners, and dealers will replace the steering shaft, free of charge. The recall began on october 28, 2015. Owners may contact dorman customer service at 1-800-523-2492, option 5.
Notes
Owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.safercar.gov.