Recalls for your 1995 Volvo Wah

Recalls for 1995 Volvo Wah

RSS Feed


3 recalls found.
All Volvo Recalls
Sorry, could not fetch this feed! (items)

DEFECT #1 - SUSPENSION:FRONT:SPRINGS:AIR SUSPENSION:LINES AND FITTINGS


Posted on: 1998-10-15
Description
Vehicle description: class 8 heavy duty trucks.  The air suspension control valve supply line was not plumbed through an air pressure protection valve.  In the event of a failure, there would be loss of air pressure in the 'b' system air reservoir that supplies air pressure for the front steer axle brakes.

Consequence
This condition would result in increased stopping distances.

Corrective Action
Dealers will install the necessary air pressure protection valve.

Notes
Owner notification began during november 1998.  Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact volvo trucks at 1-800-528-6586.also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

DEFECT #2 - SUSPENSION:REAR:SPRINGS:AIR SUSPENSION SYSTEM


Posted on: 1996-02-13
Description
The rear suspension axle retention plate can break under normal use, affecting axle alignment.

Consequence
This condition could result in loss of rear axle stability affecting vehicle directional control and increasing the potential for a vehicle crash.

Corrective Action
Dealers will remove and replace the axle retention clip plates on affected vehicles.

Notes
System: suspension; single axle; rear; air suspension.  Vehicle description: heavy duty class 8 vehicles.  Note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time, should contact volvo gm heavy truck at 1-800-528-6586.  Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

DEFECT #3 - SERVICE BRAKES, AIR:CONTROLS


Posted on: 1995-11-16
Description
Undercoating applied to the inside of the cab shell squeezed out during assembly onto the brake pedal plunger.

Consequence
Undercoating on the plunger may cause the plunger to stick resulting in increased brake pedal effort and/or slow release of the brakes increasing the potential for a vehicle accident.

Corrective Action
Dealers will clean the undercoating from the brake pedal plunger assembly, lubricate and reinstall the brake pedal plunger assembly.

Notes
System: brakes; air; pedals; linkages and valves.vehicle description: heavy duty class 8 trucks.note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact volvo gm heavy truck at 1-800-528-6586.  Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.