4 recalls found. |
DEFECT #1 - VEHICLE SPEED CONTROL:ACCELERATOR PEDAL
Posted on: 1996-03-12
Description
The coating used to protect the accelerator pedal shaft is incompatible with the bronze bushing through which the shaft passes. Over time, and in the presence of a corrosive environment (water, road salt), the shaft can corrode inside the bushing increasing the amount of friction between the rotating shaft and the stationary bushing.
Consequence
A corroded accelerator pedal shaft can cause the engine throttle to bind and not fully return to idle when the operator's foot is removed from the accelerator pedal increasing the potential for a vehicle accident.
Corrective Action
Dealers will install a revised accelerator pedal and shaft assembly.
Notes
System: fuel; throttle linkages and controls. Vehicle description: multi-purpose passenger vehicles equipped with diesel or gasoline engines. Turbo-charged diesel vehicles are not included. Note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time, should contact am general at 1-219-258-6615. Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
DEFECT #2 - SEATS
Posted on: 1996-10-22
Description
Vehicle description: buses equipped with isringhausen seats in the driver position. Two welds located on the back rest adjustment side of the seat frame did not meet the manufacturer's specifications.
Consequence
If these welds were not to specification, back rest loads could cause the welds to fail. The back rest would disengage from the seat frame allowing loss of support to the driver's torso and possibly causing loss of control of the vehicle.
Corrective Action
Isringhausen is conducting the owner notification and remedy campaign for this recall. Dealers will inspect these seats and replace the seat frame assembly.
Notes
Owner notification:isringhausen is conducting the ownernotification and remedy campaign for this recall.owner notification is expected to begin during november1996.note:owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact am general at 1-313-523-8000 or isringhausen at 1-616-968-5333, ext. 301. Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
DEFECT #3 - FUEL SYSTEM, GASOLINE
Posted on: 2006-05-22
Description
Certain replacement fuel filters, fram brand name p/n g3727, with date codes x52911 through x60801 sequentially or x600141 and a mexico country or origin marking on the fuel filter housing manufactured from october 18, 2005, through march 21, 2006, sold for use on the vehicles listed above and on certain school buses. (to see the school bus engine sizes, click on document search and then bus applications). The connector on the fuel filter was not manufactured to honeywell's specification. As a result, the o-ring may not seat correctly on the fuel line.
Consequence
This condition may cause an inadequate seal at the connection, potentially leading to a fuel leak. In the presence of an ignition source, a fire could occur.
Corrective Action
Honeywell will notify owners and replace the fuel filters free of charge. The recall began on october 18, 2006. Owners may contact fram customer service at 1-800-890-2075 (option 1).
Notes
This recall only pertains to aftermarket fram fuel filters and has no relation to any original equipment installed on the vehicles listed.customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.
DEFECT #4 - EQUIPMENT
Posted on: 2007-10-30
Description
Certain honeywell fram racing brand hp4 and hp8 oil filters that were manufactured from may 25, 2006, through september 14, 2007, and sold for use as replacement equipment for vehicles list above. The affected filters are marked with a date code a61451 through a72571 sequentially. The date code and part number appear on the filter housing. Fram racing hp4 and hp8 oil filters not bearing a date code in this range are not affected by this recall. The gasket of the oil filter becomes more pliable under high temperatures and pressures.
Consequence
This condition may cause inadequate sealing and loss of engine oil, possibly resulting in a fire.
Corrective Action
Honeywell will replace the affected oil filters free of charge. The recall began during november 2007. Owners can contact fram customer service toll-free at 1-800-890-2075.
Notes
Customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.