Recalls for your 1996 Western Star Conventional

Recalls for 1996 Western Star Conventional

RSS Feed


3 recalls found.
All Western Star Recalls

DEFECT #1 - SUSPENSION


Posted on: 1996-10-22
Description
The equalizing beam shaft of the tandem axle suspension were manufactured from as-rolled sae4140 steel rather than the specified annealed sae4140.  These shafts can fracture inside the beam at the toe of the weld.

Consequence
Vehicles are subject to vehicle tilt and possible rollover in the event that both equalizing beams, on the same side of the vehicle, experience a simultaneous shaft failure.  Affected suspensions can also drop and contact the road surface generating sparks which could ignite flammable material.

Corrective Action
Owner notification is being conducted by neway anchorlok.  Dealers will inspect and replace all suspension suspension beams with suspension beams containing appropriate shafts.

Notes
Owner notification:owner notification is being conducted by neway anchorlok and began july 18, 1996.note:owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact neway at 1-800-237-8932.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

DEFECT #2 - SERVICE BRAKES, AIR


Posted on: 1996-03-29
Description
These trucks were not built with inversion valves due to a programming error.  The inversion valve provides modulated spring brake application during emergency braking when the a portion of the air brake system has failed.

Consequence
In an emergency situation, the brake system would not work properly increasing the potential for a vehicle accident.

Corrective Action
Dealers will install an inversion valve in these vehicles.

Notes
System: brakes; air systems.  Vehicle description: straight trucks, truck/full trailer, or logging truck applications.note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time, should contact western star at 1-604-860-3319.  Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

DEFECT #3 - ELECTRICAL SYSTEM:WIRING:INTERIOR/UNDER DASH


Posted on: 1996-06-21
Description
The windshield wiper arm can interfere with the main cab dash harness which passes behind the center dash section.  The wiper arm can wear through one or more of the wires in the harness and cause a short circuit.

Consequence
In electronic engines (caterpillar only) or dda engines, the engine would stop.  If the engine were to stop suddenly when the vehicle was traveling at a high rate of speed and maneuvering through traffic, there would be a potential for a vehicle accident.

Corrective Action
Dealers will modify the main cab wiring harness routing.

Notes
System: electrical; wiring; harness; under dash.  Vehicle description: conventional trucks and truck/tractors.  Owner notification: owner notification is expected to begin june 28, 1996.  Note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time, should contact western star at 1-604-868-6222.  Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.