5 recalls found. |
DEFECT #1 - SUSPENSION:FRONT:CONTROL ARM:UPPER BALL JOINT
Posted on: 2001-07-02
Description
On certain sport utility vehicles originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, and wisconsin, and in the district of columbia. Failure of an upper control arm ball joint assembly could occur due to corrosion.
Consequence
This can result in impaired steering or steering loss, or a partial or complete collapse of the front suspension, increasing the risk of a crash.
Corrective Action
Dealers will replace both upper ball joints. Owner notification began september 4, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet at 1-800-222-1020, gmc at 1-800-462-8782, or oldsmobile at 1-800-442-6537.
Notes
Also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
DEFECT #2 - SUSPENSION:FRONT:CONTROL ARM:UPPER BALL JOINT
Posted on: 2002-01-07
Description
This is not a safety recall in accordance with the safety act. However, it is deemed a safety improvement campaign by the agency. Vehicle description: 1996-1997 4-wheel drive chevrolet blazer, gmc jimmy, and oldsmobile bravada sport utility vehicles. Some owners have had to pay for replacement of the upper ball joints that have separated. Gm is providing a special policy to these owners to cover upper ball joint replacement if the customer followed the recommended maintenance schedule for the chassis lubrication and the vehicle still required the replacement of the upper ball joints due to separation.
Consequence
This could cause a loss of steering control of the vehicle.
Corrective Action
Gm has decided to conduct a customer satisfaction campaign to replace the upper ball joints on affected vehicles. This special policy is for a period of 8 years or 100,000 miles, whichever occurs first, from the date the vheicle was originally placed in service, regardless of ownership. The upper ball joint replacement, due to separation, will be made at no charge to the customer during this period. Owners can contact chevrolet at 1-800-222-1020, gmc at 1-800-862-4389, or oldsmobile at 1-800-442-6537, concerning this program.
Notes
DEFECT #3 - SEAT BELTS
Posted on: 1997-08-21
Description
Vehicle description: extended cab pickup trucks equipped with 60/40 front bench seats and extended cab pickup trucks and 2-door utility vehicles equipped with manual locking recliner bucket seats. The outboard safety belt webbing on the driver's and/or passenger's seat can separate during a frontal impact.
Consequence
If a separation occurred and there were secondary crash events or vehicle rollover, there would be no belt restraint of the occupant and increased injuries could occur.
Corrective Action
Dealers will install a protective cover over the recliner mechanism.
Notes
Owner notification:owner notification will begin during september 1997. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet at 1-800-222-1020 or gmc at 1-800-462-8782.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
DEFECT #4 - SEAT BELTS:FRONT:BUCKLE ASSEMBLY
Posted on: 2003-04-01
Description
Certain sport utility vehicles were built with a driver's seat belt buckle assembly that contains an energy-absorbing loop. Sustained loads of sufficient magnitude and duration on the belt in severe crashes could fully deploy the buckle energy-absorbing loop, introducing a total of 10 additional inches of webbing into the seat belt system. The free falling latch plate used in this system may allow webbing to dynamically distribute between the lap and shoulder belt as the driver's position changes during a multiple rollover event.
Consequence
If the energy-absorbing loop fully deploys in a severe multiple rollover crash, it is possible that a belted driver may experience partial or even complete ejection from the vehicle.
Corrective Action
Dealers will replace the energy-absorbing seat belt assemblies with one that does not have the energy-absorbing loop. Owner notification began on august 8, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet at 1-800-222-1020, gmc at 1-800-462-8782, or oldsmobile at 1-800-442-6537.
Notes
Gm recall no. 03020.customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
DEFECT #5 - VISIBILITY:REARVIEW MIRRORS/DEVICES:EXTERIOR
Posted on: 2003-03-18
Description
Certain sport utility vehicles, mini vans, and pickup trucks may develop a short circuit in the electric outside rearview mirror switch.
Consequence
If this were to happen, it could result in an inoperative switch, heat damage to the driver's door, and/or ignition of components in the driver's door and a subsequent vehicle fire without prior warning.
Corrective Action
Dealers will install a fused jumper harness to the electric outside rearview mirror switch. Owner notification began on april 24, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet at 1-800-222-1020 or gmc at 1-800-462-8782.
Notes
Gm recall no. 03006. Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).