Recalls for your 1998 Kenworth C500

Recalls for 1998 Kenworth C500

RSS Feed


3 recalls found.
All Kenworth Recalls
Kenworth C500T

Moonayyy posted a photo:

Kenworth C500T

DEFECT #1 - SUSPENSION:FRONT:CONTROL ARM:LOWER ARM


Posted on: 2001-02-28
Description
Vehicle description: vehicles equipped with 54 rear axle spacing configuration of the airglide 200 suspension with the service application identified as logger, dump truck, or tanker.  The rear suspension is regularly subjected to extreme articulation, resulting in flexing of the joint.

Consequence
Failure of the lower sway arm attaching bolts could result in loss of vehicle control.

Corrective Action
Dealers will replace the lower sway arm brackets.  Owner notification began march 27, 2001.  Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5000.

Notes
Also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

DEFECT #2 - ELECTRICAL SYSTEM:WIRING:FRONT UNDERHOOD


Posted on: 1998-06-17
Description
Vehicle description: heavy duty trucks equipped with caterpillar 3406e engines.  The routing of the electrical and fuel lines can cause chaffing of the wiring harness on the fuel line.

Consequence
This chaffing can cause fuel leakage and a potential for a fire in the engine compartment.

Corrective Action
Dealers will inspect, adjust, and repair, if necessary, the fuel line and electrical harness.

Notes
Owner notification is expected to begin during july 1998.owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-206-828-5418.also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

DEFECT #3 - SERVICE BRAKES, AIR


Posted on: 2003-04-02
Description
Certain trucks equipped with meritor p 18x7 brakes with 36 brake chambers fail to comply with the requirements of federal motor vehicle safety standard (fmvss) no.  121, air brake systems.  These trucks were manufactured with a combined air reservoir volume less than 12 times the combined volume of all service brake chambers.  

Consequence
This does not meet the requirements of the standard.

Corrective Action
Dealers will add an additional tank or change one of the existing air tanks to a larger size.  Owner notification began on may 5, 2003.  Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5440.  

Notes
Kenworth recall no.  03kw3.  Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).