3 recalls found. |
DEFECT #1 - SUSPENSION:FRONT:CONTROL ARM
Posted on: 2004-11-04
Description
On certain trucks, the tie rod end ball joint dust boot was designed with insufficient sealing ability. This condition could allow contamination to enter into the tie rod end ball joint, abnormally wearing the resin bearing located inside the joint.
Consequence
The tie rod end ball joint could separate from the tie rod end, disabling the steering system, and causing a crash.
Corrective Action
Dealers will install modified tie rod end assemblies. The recall began on january 13, 2005. Owners should contact mitsubishi fuso at 856-467-3917.
Notes
Mitsubishi fuso recall no. R3128610.customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
DEFECT #2 - PARKING BRAKE:CONVENTIONAL:MECHANICAL:LINKAGE AND CABLE
Posted on: 2004-12-03
Description
On certain trucks, the cable end of the parking brake cable, where it attaches to the parking brake lever, is designed improperly. Repeated normal parking brake operation may cause the cable end to become improperly seated in the parking brake lever groove.
Consequence
In this condition, the parking brake cable may bend and break due to fatigue. The parking brake may become inoperative and the truck may roll and cause a crash, property and personal injuries.
Corrective Action
Dealers will inspect the parking brake cable for bending or damage at the cable end and install a modified parking brake cable assembly if the cable is bent or damaged at the cable end. If no bending or damage exists, dealers will install a cable retainer on the cable end of the parking brake cable. The recall began on january 13, 2005. Owners should contact mitsubishi fuso at 1-877-711-0707.
Notes
Mitsubishi fuso recall no. C0021610.customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
DEFECT #3 - EXTERIOR LIGHTING:HEADLIGHTS
Posted on: 2009-03-30
Description
Mitsubishi fuso truck of america (mfta) is recalling 156 halogen sealed beam high beam headlamp assemblies sold between october 24, 2007 and december 2, 2008 for use as replacement equipment for certain mitsubishi fuso trucks. These lamps fail to conform to the sae standards or recommended practices referenced in table i of federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.
Consequence
The purpose of this standard is to reduce deaths and injuries from motor vehicle crashes by providing adequate illumination of the roadway.
Corrective Action
Mfta will notify owners and replace the headlamps free of charge. The safety recall began on april 15, 2009. Owners may contact mfta at 1-856-467-4500.
Notes
Mfta's recall no. C1003910.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov .