3 recalls found. |
DEFECT #1 - ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:MANIFOLD/HEADER/MUFFLER/TAIL PIPE
Posted on: 1979-10-12
Description
Exhaust emissions (carbon monoxide) may enter the interior of the vehicle when the exhaust pipe is substantially out the design position, deteriorated from use, or when an opening in the body develops near the exhaust outlet and, at the same time, a negative air pressure occurs in the vehicle interior.
Consequence
Under these conditions, vehicle occupants may experiencecarbon monoxide poisoning.
Corrective Action
Reseal nearby body joints and replace the draw plug in the body which was used to remove surplus bonderizing solution during manufacture.
Notes
System: exhaust.vehicle description: passenger cars.
DEFECT #2 - ENGINE AND ENGINE COOLING:ENGINE
Posted on: 1981-06-12
Description
There is a possibility that a separated motor mount may allow the engine to lift, which may affect the throttle linkage, momentarily increasing throttle, possibly to full throttle.
Consequence
Unexpected loss of throttle control may cause loss ofvehicle control and an accident.
Corrective Action
Inspect engine mounts and install restraints which will limit engine lift and eliminate possible secondary effects to the throttle linkage due to engine mount separation.
Notes
System: engine.vehicle description: passenger vehicles, light trucks and vans.
DEFECT #3 - STEERING:LINKAGES:ARM:IDLER AND ATTACHMENT
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that, after extended mileage, the idler arm assembly could separate during vehicle operation and result in a severe pull to the right as brakes are applied at low to moderate speed.(inspect and re- place idler arm assembly as required.)