Recalls for your 1968 Dodge S500

Recalls for 1968 Dodge S500

RSS Feed


4 recalls found.
All Dodge Recalls
Sorry, could not fetch this feed! (items)

DEFECT #1 - SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS


Posted on: 1979-10-12
Description


Consequence


Corrective Action


Notes
Possibility that front wheel brake hose could contact steering knuckle arm nutor cotter pin.this could cause chafing of brake hose which could result inloss of brake fluid and subsequent loss of braking ability.(correct byinstalling hose bracket where necessary.)

DEFECT #2 - SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS


Posted on: 1979-10-12
Description


Consequence


Corrective Action


Notes
Chrysler campaign no 110t.trucks.possibility that the flexible brake hosesconnecting the lower and upper brake master cylinder tubes may have beenimproperly clipped and routed.if this condition exists contact between thebrake hoses and steering column shaft coupling may be possible, with chafing ofthe hose resulting in a brake fluid leak and reduction of brakingeffectiveness.(correct by inspecting and rerouting flexible hose and replacewhere necessary.

DEFECT #3 - STEERING:LINKAGES:TIE ROD ASSEMBLY


Posted on: 1979-10-12
Description


Consequence


Corrective Action


Notes
Chrysler campaign no 071t.truck equipped with 7,000 lb.fro nt axle andpower steering.possibility that under some condi tions original powersteering cylinder tie rod clamp may not p rovide sufficient clamping force toprevent movement on rod, c ould result in partial loss of steering control.(correct byreplacing clamp assembly where necessary.)

DEFECT #4 - STEERING:LINKAGES:ROD:RELAY:CONNECTING


Posted on: 1979-10-12
Description


Consequence


Corrective Action


Notes
Possibility that original power steering cylinder tie rod clamp may not provide sufficient clamping force to prevent movement on rod under some conditions.movement could result in partial loss of steering control.(correct by replacing clamp assembly when necessary.)