4 recalls found. |
DEFECT #1 - ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:MANIFOLD/HEADER/MUFFLER/TAIL PIPE
Posted on: 1979-10-12
Description
Exhaust emissions (carbon monoxide) may enter the interior of the vehicle when the exhaust pipe is substantially out the design position, deteriorated from use, or when an opening in the body develops near the exhaust outlet and, at the same time, a negative air pressure occurs in the vehicle interior.
Consequence
Under these conditions, vehicle occupants may experiencecarbon monoxide poisoning.
Corrective Action
Reseal nearby body joints and replace the draw plug in the body which was used to remove surplus bonderizing solution during manufacture.
Notes
System: exhaust.vehicle description: passenger cars.
DEFECT #2 - STRUCTURE: FRAME AND MEMBERS:UNDERBODY SHIELDS
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that filler plate was omitted from left rear floor pan area betweenbumper and fuel tank.if this plate is missing it could allow dust and, undercertain conditions, exhaust fumes to enter passenger compartment.(correct byinspecting and installing filler plate when necessary.)
DEFECT #3 - TIRES
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that firestone tires (8.25 x 14 white sidewall 4-ply rated), maynot meet minimum strength requirements.failure in body of tire could resultin loss of tire pressure.(correct by re- placing all tires with new improvedtype.)
DEFECT #4 - ENGINE AND ENGINE COOLING:ENGINE
Posted on: 1981-06-12
Description
There is a possibility that a separated motor mount may allow the engine to lift, which may affect the throttle linkage, momentarily increasing throttle, possibly to full throttle.
Consequence
Unexpected loss of throttle control may cause loss ofvehicle control and an accident.
Corrective Action
Inspect engine mounts and install restraints which will limit engine lift and eliminate possible secondary effects to the throttle linkage due to engine mount separation.
Notes
System: engine.vehicle description: passenger vehicles, light trucks and vans.