1974 Alouette Ax125 Recall Information and Defects
The 1974 Alouette Ax125 has 4 active safety recalls issued by the NHTSA and ALOUETTE REC PRODUCTS,INC. These critical defects primarily concern pedals and linkages, structure, and mounting. Review the full details below, including NHTSA and Manufacturer Campaign numbers.
Quick Jump to Recalls (4 Defects)
Defect #1: Pedals And Linkages Malfunction (MFR Campaign: )
NHTSA ID: 74V178000 | MFR Campaign Number:
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Alouette campaign no n/a. Motorcycle. Possibility that the rear brake pedallever, where it is attached to the lever counter shaft, is subject to weldjoint failure. If this condition exists, loss of rear braking capability wouldresult. (correct by inspecting and installing re-inforcing kit)
Defect #2: Structure Malfunction (MFR Campaign: )
NHTSA ID: 74V179000 | MFR Campaign Number:
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Alouette campaign no n/a. Motorcycle. Possibility that the kick stand endstoppers, part of the rear fork assembly, was inadequately welded onto the forkassembly. (correct by inspecting and installing re-inforcing kit)
Defect #3: Mounting Malfunction (MFR Campaign: )
NHTSA ID: 74V180000 | MFR Campaign Number:
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Alouette campaign no n/a. Motorcycle. Possibility of fuel leakage between thefuel tank and the valve body. If this condition exist fuel could run down anddrip onto hot muffler causing a potential fire hazard. (correct by inspectingand repair with modification kit)
Defect #4: Service Brakes, Hydraulic Malfunction (MFR Campaign: )
NHTSA ID: 74V181000 | MFR Campaign Number:
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Alouette campaign no n/a. Motorcycle. Possibility that the rear brake backplate holder lock nut insufficiently torqued. If the lock nut vibrate off andbolt fall out instant rear brake locking could occur. (correct by inspectingand installing proper length back platesholder bolts)
