5 recalls found. |
DEFECT #1 - ENGINE AND ENGINE COOLING:ENGINE
Posted on: 1979-10-12
Description
In the event of turbocharger compressor wheel failure, one or more of the four capscrews that hold the turbocharger together may be struck by parts of the compressor wheel, resulting in the capscrews being damaged. If these capscrews are damaged to the point that they allow the compressor back plate to dislocate from the turbocharger bearing housing, engine lubricating oil may be allowed to escape under pressure, contacting the engine exhaust manifold sections or turbocharger turbine housing.
Consequence
Corrective Action
Dealer will install a shield for the heads of the four capscrews, along with stronger sae 8 grade 8 capscrews, if necessary, at no cost to owner.
Notes
Vehicle description: trucks equipped with endt (b) 676, etaz (b) 673a, and etay(b) 673a engines.system: engine and engine cooling.consequences of defect: engine lubricating oil, in the presence of a source ofignition, could lead to an engine compartment fire and serious injury tovehicle passengers.
DEFECT #2 - STEERING:LINKAGES
Posted on: 1979-10-12
Description
The pitman arm retaining nut may not have been torqued to manufacturer specifications. This could result in inadequate retention of the nut at the output shaft, allowing the pitman arm to become loose.
Consequence
Corrective Action
Dealer will inspect and retorque pitman arm, if necessary, at no cost to owner.
Notes
Vehicle description: trucks.system: steering linkages; arm, pitman.consequences of defect: this condition could lead to premature wearing of theoutput shaft causing loss of vehicle control and an accident.
DEFECT #3 - SERVICE BRAKES, AIR:ANTILOCK:INTERCONNECTING ASSEMBLY(WIRING)
Posted on: 1979-10-12
Description
Delays of up to about 2 seconds may exist in the brake application times to the brakes on the bogie axles in the presence of certain types of wheel speed sensor signal discontinuities or distortions that may occur as a result of sensor wire failure. This constitutes a non-compliance to federal motor vehicle safety standard no. 121, air brake systems.
Consequence
Corrective Action
Dealer will install new wheel speed sensors that incorporate improved wiring and the present bogie anti-wheel lock system will be changed to an axle-to-axle system for improved reliability.
Notes
Vehicle description: heavy trucks.system: service brakes; electrical wiring and connectors.consequences of defect: this delay in effective braking action could lead to anaccident under certain traffic conditions.
DEFECT #4 - ENGINE AND ENGINE COOLING:ENGINE
Posted on: 1979-10-12
Description
The possibility exists that the aluminum engine rear support brackets may fail due to metal fatigue. This type of failure would allow the engine and transmission assembly to dislocate downward. This will result in throttle control loss with the engine operating continuously in the mid to upper range of the governed speed range.
Consequence
Corrective Action
Dealer will inspect and, if necessary, replace aluminum support brackets with brackets made from ductile iron for increased strength.
Notes
Vehicle description: trucks.system: engine; engine mounting bracket.consequences of defect: loss of throttle control may result in loss of vehiclecontrol and an accident.
DEFECT #5 - ELECTRICAL SYSTEM:WIRING
Posted on: 1979-10-12
Description
A short circuit could occur due to chafing or wire disconnection in the box.
Consequence
Corrective Action
The wiring in the sleeper box will be corrected, free of charge.
Notes
Vehicle description: heavy truck tractors equipped with the able body companyssleeper box.consequences of defect: a short circuit creates a potential fire hazard whichcould jeopardize the safety of vehicle occupants.