2 recalls found. |
DEFECT #1 - SERVICE BRAKES, AIR:DRUM:SHOES/LININGS
Posted on: 1979-10-12
Description
The brake shoe welds on the rear brake assemblies could fail at the point where the weld joins the brake shoe table. A broken weld could result in loss of braking capability.
Consequence
Corrective Action
The brake shoe assemblies will be inspected and replaced, if necessary.
Notes
Vehicle description: bus chassis equipped with rockwell international q148brake shoe assembly.system: service brakes; brake shoes.consequences of defect: loss of braking capability could result in loss ofvehicle control and an accident.
DEFECT #2 - SUSPENSION:REAR
Posted on: 1980-07-31
Description
The bolts that clamp the mor/ryde suspension beam and lower mounting plate to the axle may break as a result of misalignment of the bolts due to non-parallel surfaces of the upper beam plate and the lower bottom plate. Another contributing factor is the absence of shear blocks to the upper spacer pad.
Consequence
Corrective Action
Manufacturer will install new mor/ryde beam assemblies, lower mounting plates, bolts, nuts and washers.
Notes
Vehicle description: buses equipped with 10 inch rear brakes and mor/rydesuspension.system: suspension; rear engine axle, mounting bolts.consequences of defect: this condition could allow the axle to shift, possiblyresulting in loss of vehicle control and an accident.note: owner is advised to inspect the vehicle weekly for cracked or brokenbolts until the condition is corrected.