|
|
Recalls for
1981 Autocar Autocar
|
2 recalls found.
|
DEFECT #1 - STEERING:WHEEL AND HANDLE BAR
Posted on: 1981-10-27
Description
Steering shaft binder bolts on certain vehicles are either loose or over-tightened. Either condition can lead to a separation of the steering shaft from the steering column, even if the factory installed bolt has been properly retightened.
Consequence
Corrective Action
Unique bolts have been designed for this campaign and will be installed along with new nuts. This will be done at no charge to owner.
Notes
Vehicle description: trucks.system: steering; steering shaft binder bolts.consequences of defect: shaft separation could result in loss of vehiclecontrol and an accident.note: as a precaution, immediately check the binder bolts on the steering shaftfor looseness. If they are loose, tighten them to 60 ft-lbs torque. Tighteningbolts does not permanently remedy the defect. New bolts and nuts must beinstalled. DEFECT #2 - LATCHES/LOCKS/LINKAGES:DOORS:LATCH
Posted on: 1983-04-06
Description
In certain types of collisions, the door latches may release and the door could open. The door latch system fails to conform to federal motor vehicle safety standard 206, door locks and door retention components.
Consequence
Corrective Action
Dealer will install new door latch control rods at no cost to the owner.
Notes
Vehicle description: heavy trucks.system: structure; door latch assembly.consequences of defect: in a rear-end collision, the occupants may be thrownfrom the vehicle, increasing the chances of injury.note: the owner should make sure that seat belts are fastened to lessen thechances of occupant ejection.