7 recalls found. |
DEFECT #1 - STRUCTURE
Posted on: 1988-08-16
Description
Luggage rack above the seats protrudes into the upper limit of the head impact zone.
Consequence
Buses do not comply with fmvss 222.
Corrective Action
Reposition luggage rack.
Notes
System: luggage rack/fmvss 222.vehicle description: school buses.
DEFECT #2 - STRUCTURE:BODY
Posted on: 1987-07-13
Description
Opening the roof hatch past 90 degrees can disengage the hinge pin retainer ring allowing the hinge pins to work out.
Consequence
Roof hatch could separate from the bus and injureindividuals in the vicinity.
Corrective Action
Install two hinge pins to prevent roof hatch separation.
Notes
System: roof hatch.vehicle description: buses and school buses with emergency roof exists.
DEFECT #3 - SEAT BELTS:FRONT
Posted on: 1988-11-18
Description
Movable part of seat is not strong enough to support the seat belt.
Consequence
Seat belt may not properly restrain driver.
Corrective Action
Install a tether strap.
Notes
System: seat belt.vehicle description: buses and school buses with suspension type drivers seats.
DEFECT #4 - LATCHES/LOCKS/LINKAGES:DOORS:LATCH
Posted on: 1985-02-22
Description
The rack and gear type latch assembly of the emergency doors can be overstressed by misuse of the inside door handle, making the gears subject to failure. Consequence of defect: it is possible for these gears to fail when the door is closed, making it impossible to open the emergency door. This could result in passengers being trapped in case of emergency.
Consequence
Corrective Action
Install complete new latch assemblies with metal gears to replace the nylon material.
Notes
Vehicle description: school bus with gvwr greater than 10,000 pounds.system: emergency door latch assembly.
DEFECT #5 - FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS
Posted on: 1985-12-03
Description
The body is subject to shift forward during an impact and the fuel filler hose and/or fuel vent line hose may separate from either the fuel filler neck or the gas tank. This does not comply with fmvss 301. Consequence of defect: a fuel spill could occur and possibly result in a fire.
Consequence
Corrective Action
Install new fuel filler and vent line hoses, which are capable of being stretched beyond the extent to which the body could shift forward during a 30 mph frontal impact.
Notes
System: fuel/fmvss 301. Vehicle description: school bus with gvwr of 10,000 lbs. Or less and buses over 10,000 lbs.
DEFECT #6 - EXTERIOR LIGHTING:TURN SIGNAL:SWITCH
Posted on: 1984-11-07
Description
The turn signal mechanism in the steering column may break; the broken piece may become jammed in the steering column. While using the turn signal and turning in either direction, the operator may experience either increased steering effort in the turn, or binding in the steering wheel when the wheel is returned to a straight position.
Consequence
Corrective Action
A replacement switch will be made available to owners; owner has the option to make the repair himself or have it done by a dealer. There will be no charge to the owner for the switch or the repair.
Notes
Vehicle description: buses without floor mounted turn signal switches.system: lighting and communications; turn signal switch.consequences of defect: increased steering effort or binding could result inloss of vehicle control and an accident.
DEFECT #7 - STRUCTURE
Posted on: 1985-11-13
Description
Sanders were installed without reinforcement plates at point where mounting angle brackets are attached to the bus body floor channel. Floor channel may crack, possibly allowing the sander to become detached from the bus body floor channel. Consequence of defect: if sander becomes detached it will pose a safety hazard to other vehicle on the highway.
Consequence
Corrective Action
Install reinforcement plates to prevent cracking of floor channel.
Notes
System: structure/reinforcement plates.vehicle description. Buses produced with optional electric traction sanders located ahead of the rear wheels.