Recalls for your 1990 Buick Regal

Recalls for 1990 Buick Regal

RSS Feed


9 recalls found.
All Buick Recalls
Buick Regal

Chad Horwedel posted a photo:

Buick Regal

DEFECT #1 - STRUCTURE


Posted on: 2000-07-12
Description
Vehicle description: passenger vehicles originally sold or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin, and the district of columbia, where road salt use is heavy.  A condition where one or both front engine cradle bolts can pull through the retainers due to corrosion of the retainers.

Consequence
If both bolts pull through, the front of the cradle would no longer be supported at the mounting locations and the steering intermediate shaft could separate from the steering gear.

Corrective Action
Dealers will replace the front and rear frame/cradle bolts and retainers.

Notes
Owner notification began september 28, 2000.  Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet at 1-800-222-1020, buick at 1-800-521-7300, pontiac at 1-800-762-2737, or oldsmobile at 1-800-442-6537.  Also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

DEFECT #2 - STRUCTURE


Posted on: 1997-04-17
Description
Vehicle description: passenger vehicles and mini vans originally sold or currently registered in the following states: connecticut, illinois, indiana, maine, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont and wisconsin.  The rear cradle bolts pull through the retainers due to corrosion of the retainer.  If both bolts pull through, the rear cradle would not longer be supported at these mounting locations and the steering intermediate shaft can separate from the steering gear.

Consequence
If this were to occur while the vehicle was in motion, a vehicle crash could result.

Corrective Action
Dealers will replace the rear cradle bolts and retainers.  

Notes
Owner notification is expected to begin during may 1997.note:owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact buick at 1-800-521-7300, chevrolet at 1-800-222-1020, oldsmobile at 1-800-442-6537, or pontiac at 1-800-762-2737.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

DEFECT #3 - WHEELS


Posted on: 1995-06-13
Description
Cracks develop in the wheel mounting surface.  If these cracks become severe enough, the wheel will completely separate from the vehicle.

Consequence
If wheel separation occurs while the vehicle is in motion, loss of steering and brake control of the vehicle occurs, and a vehicle crash could result without prior warning.

Corrective Action
Dealers will inspect the manufacturing date codes stamped on each wheel of the vehicle and if a wheel falls within the specified date code range, the dealer will replace that wheel assembly.

Notes
System: wheels.vehicle description: passenger vehicles equipped with kelsey hayes steelwheels; models rpo pb9 14 and pg1 15.note: vehicles previously inspected that had less than four wheels replaced in recall campaign 94v-041 are to be reinspected.note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time,should contact chevrolet at 1-800-222-1020; buick at 1-800-521-7300; pontiac at 1-800-762-2737; or oldsmobile at 1-800-442-6537.  Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

DEFECT #4 - WHEELS


Posted on: 1995-04-06
Description
Cracks develop in the wheel mounting surface.  If these cracks become severe enough, the wheel will completely separate from the vehicle.

Consequence
If wheel separation occurs while the vehicle is in motion, loss of steering and brake control of the vehicle occurs, and a vehicle crash could result without prior warning.

Corrective Action
Dealers will inspect the manufacturing codes stamped on each wheel of the vehicle and if a wheel falls within the specified date code range, the dealer will replace that wheel assembly.

Notes
System: wheels.vehicle description: passenger vehicles equipped with kelsey hayes steel wheels; models rpo pb6 14 and rpo pg1 15.note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided free of charge within a reasonable time, please contact chevrolet at 1-800-222-1020; oldsmobile at 1-800-442-6537; pontiac at 1-800-762-2737; or buick at 1-800-521-7300.  Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

DEFECT #5 - SEAT BELTS


Posted on: 1991-02-19
Description
Front shoulder safety belt webbing may separate at front belt upper guide loops on either side of the front seat.

Consequence
Webbing separation could occur without prior warning andincrease the risk of injury to belted front outboard occupants in a high energycrash.

Corrective Action
Install a controlled rotation bracket on driver and passenger side front seat belt guide loops.

Notes
System: front shoulder safety belt.vehicle description: passenger cars.

DEFECT #6 - EXTERIOR LIGHTING:BRAKE LIGHTS:SWITCH


Posted on: 1990-10-26
Description
Brake stoplamps may not illuminate or, in some cases, stoplamps will not stay illuminated all the time when brakes are applied due to a faulty stoplamp switch.  Also in vehicles equipped with cruise control, a faulty stoplamp switch can result in resumption of the cruise control function upon release of the brake pedal.

Consequence
A trailing vehicle may not recognize a braking actionin time to respond appropriately.  Also, cruise control will reengage uponrelease of the brake pedal and resume the set speed.  In either case, it couldresult in a crash without prior warning.

Corrective Action
Install an improved design stoplamp switch.

Notes
System: brake stoplamp switch.vehicle description: passenger cars.note: also see nhtsa recall 92v086000.

DEFECT #7 - SEAT BELTS:FRONT:WEBBING


Posted on: 1990-06-18
Description
Owners manuals did not fully explain how front shoulder belt comfort feature works.

Consequence
Cars would not comply with fmvss 208, and incorrect use of safety restraints could lead to personal injury to occupants if an accidentshould occur.

Corrective Action
Insert sticker that provides missing information in owners manuals.

Notes
System: safety belts; fmvss 208.vehicle description: passenger cars.

DEFECT #8 - SEAT BELTS


Posted on: 1990-07-19
Description
Front shoulder belt guide loop attachment fastener may pull through door mounted anchor plate.

Consequence
Seat belt may not sustain loads required by fmvss 210, and in a vehicle accident, the seat belt may not properly restrain a passenger, resulting in increased risk of greater injury to an occupant.

Corrective Action
Replace front shoulder belt guide loop attachment nuts and install new guide cover.

Notes
System: seat belt anchorage; fmvss 210.vehicle description: passenger cars.

DEFECT #9 - FUEL SYSTEM, GASOLINE


Posted on: 2006-05-22
Description
Certain replacement fuel filters, fram brand name p/n g3727, with date codes x52911 through x60801 sequentially or x600141 and a mexico country or origin marking on the fuel filter housing manufactured from october 18, 2005, through march 21, 2006, sold for use on the vehicles listed above and on certain school buses.  (to see the school bus engine sizes, click on document search and then bus applications).  The connector on the fuel filter was not manufactured to honeywell's specification.  As a result, the o-ring may not seat correctly on the fuel line.

Consequence
This condition may cause an inadequate seal at the connection, potentially leading to a fuel leak.  In the presence of an ignition source, a fire could occur.

Corrective Action
Honeywell will notify owners and replace the fuel filters free of charge.  The recall began on october 18, 2006.  Owners may contact fram customer service at 1-800-890-2075 (option 1).

Notes
This recall only pertains to aftermarket fram fuel filters and has no relation to any original equipment installed on the vehicles listed.customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.