3 recalls found. |
DEFECT #1 - FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS
Posted on: 1994-04-13
Description
Feed fuel hoses can harden and set over time, allowing a seepage of fuel at the connection between the hose and the engine fitting. The clamp used to hold the hose to the fitting is unable to compensate for the hardening of the feed fuel hose.
Consequence
Fuel seepage between the feed fuel hose and the engine fitting can result in free fuel in the engine compartment, which could result in a fire when exposed to a source of ignition.
Corrective Action
A redesigned feed fuel hose and hose clamp will be installed to alleviate the fuel seepage.
Notes
System: fuel; fuel line fittings; metallic.vehicle description: passenger vehicles; models 318i, 318si, 318ic, 325i, 325is, 325ix, 325ic, 525i, 535i, 735i and 735il.note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided within a reasonable time and free of charge, or the remedy does not correct the defect or noncompliance, please contact bmw at 1-800-831-1117. Also, contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
DEFECT #2 - VISIBILITY:DEFROSTER/DEFOGGER SYSTEM:WINDSHIELD:HEATER CORE
Posted on: 1993-02-05
Description
The malfunction or failure of a coolant system component results in significantly increased coolant temperature and a resulting increase in system pressure.
Consequence
Vehicles operated under this increased cooling systempressure condition can suffer damage or failure of parts of the cooling systemsuch as (1) leakage from a coolant hose, (2) leakage of the radiator orexpansion tank, (3) disconnection of a hose from a pipe or a fitting, and (4)cracks in the heater core end piece resulting in coolant leakage. In some cases,boiling coolant can contact the lower right leg of the driver resulting inburns. Also, escaping coolant in the passenger compartment can cause vaporfogging of the interior surface of the windows, reducing driver visibility.
Corrective Action
Dealers will install a thermostatic bypass valve in the engine compartment to control coolant temperature in the heater core. Also, a new design radiator cap will be installed, to control pressure and provide greater coolant overflow in the event of overheating.
Notes
System: coolant system.vehicle description: passenger cars.
DEFECT #3 - VEHICLE SPEED CONTROL
Posted on: 1991-12-20
Description
The crankcase ventilation system, vented into the intake tract of the engine at the bellows boot ahead of the throttle housing, allows warm water vapor from the crankcase vent to condense and freeze in the colder bellows boot when the ambient air temperature is 15 degrees fahrenheit or less. The build up of ice can dislodge and move into the throttle housing, preventing the throttle plate from fully closing when the driver releases the gas pedal.
Consequence
If the throttle plate is prevented from closing, thereis an increase in idle speed as well as slower than normal deceleration, whichoccurs without prior warning and could result in an accident.
Corrective Action
Replace the throttle housing with a version containing a modified heating system along with rerouting of the cvs hose. This will prevent ice build-up in the intake tract.
Notes
System: throttle linkages and control.vehicle description: passenger vehicles.