Recalls for your 1992 Porsche 911

Recalls for 1992 Porsche 911

RSS Feed


4 recalls found.
All Porsche Recalls
AO2_2317.jpg

Former Instants Photo posted a photo:

AO2_2317.jpg

DEFECT #1 - STEERING:WHEEL AND HANDLE BAR


Posted on: 1996-08-08
Description
A part of the steering column upper universal joint cracked during the manufacturing process.

Consequence
This condition could result in noise and free play in the steering system and if left uncorrected, will result in loss of steering control.

Corrective Action
Dealers will inspect the universal joint for cracks and will replace cracked joints with new parts.

Notes
Owner notification:owner notification is expected to begin during august 1996.  Note:owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact porsche at 1-800-545-8039.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

DEFECT #2 - ELECTRICAL SYSTEM:FUSES AND CIRCUIT BREAKERS


Posted on: 1993-12-16
Description
After the engine has been turned off, the rear heater will automatically operate in order to dissipate heat in the engine heating system.  During this operation, the resistor for the rear heater blower can become overloaded due to a binding or seized rear heater blower.

Consequence
The overloaded resistor can create heat sufficient toignite the plastic air pipe to which it is connected, resulting in an enginecompartment fire.

Corrective Action
Porsche dealers will install a new resistor containing a circuit breaker.

Notes
System: heater; water; defroster; circuit breaker.vehicle description: passenger vehicles.note: if your vehicle is presented to an authorized dealer on an agreed uponservice date and the remedy is not provided within a reasonable time and freeof charge or the remedy does not correct the defect or noncompliance, pleasecontact porsche service center at 1-800-545-8039.  Also contact the nationalhighway traffic safety administration's auto safety hotline at 1-800-424-9393.

DEFECT #3 - SERVICE BRAKES, HYDRAULIC:POWER ASSIST:VACUUM:HOSES, LINES/PIPING, AND FITTINGS


Posted on: 1993-12-16
Description
The hydraulic brake pressure reduction valve causes the rate of hydraulic pressure reduction to slow down, which may result in the rear wheels locking-up even with the anti-lock brake system in operation.

Consequence
Rear wheel lock-up may result in loss of vehiclecontrol and an accident.

Corrective Action
Porsche dealers will install a modified hydraulic brake pressure reduction valve.

Notes
System: brakes; hydraulic; power assist; check valve.vehicle description: passenger vehicles; models 911 turbo and 911 americaroadster.note: if your vehicle is presented to an authorized dealer on an agreed uponservice date and the remedy is not provided within a reasonable time and freeof charge or the remedy does not correct the defect or noncompliance, pleasecontact porsche service center at 1-800-545-8039.  Also contact the nationalhighway traffic safety administration's auto safety hotline at 1-800-424-9393.

DEFECT #4 - VEHICLE SPEED CONTROL


Posted on: 1992-10-16
Description
The ball sockets on the cruise control linkage can break, allowing the cruise control linkage to become detached on one end and jam on nearby components, which could impair throttle plate operation.

Consequence
Impaired throttle plate operation could prevent theengine from returning to idle, resulting in unwanted engine speed and possiblevehicle accident.

Corrective Action
Replace the current plastic ball sockets with a new linkage using steel ball sockets, and lubricate the cruise control relay lever.  Owners are advised not to use the cruise control until the modification is installed.

Notes
System: cruise control.vehicle description: passenger cars; carrera 2 and carrera 4 models.