4 recalls found. |
DEFECT #1 - AIR BAGS:FRONTAL:SENSOR/CONTROL MODULE
Posted on: 1999-05-12
Description
Vehicle description: passenger vehicles. Moisture can enter the air bag inflatable restraint electronic control module (ecm) and cause corrosion on portions of the ecm printer circuit boards.
Consequence
This corrosion can possibly create open connections in circuits which control the restraint deployment, possibly causing inadvertent air bag deployment.
Corrective Action
Dealers will inspect the exterior of the ecm. If there is no indication of moisture, a cover will be installed over the ecm. If there is indication of moisture, the dealer will replace the ecm and install a cover over the new ecm.
Notes
Owner notification began july 5, 1999.owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact saab at 1-800-955-9007. Also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
DEFECT #2 - ENGINE AND ENGINE COOLING:COOLING SYSTEM
Posted on: 1994-07-13
Description
During low energy frontal impact collisions, the front crossmember can contact the metal tubing portion of the cooler hose assembly; and/or the hose assembly can break and leak oil onto the hot exhaust manifold or the turbocharger.
Consequence
Oil leaking on these hot engine surfaces can ignite and cause a vehicular fire.
Corrective Action
Dealers will install a protective cover which will protect the cooler and hoses from other structural components in low energy front impacts.
Notes
System: engine cooling system. Vehicle description: passenger cars equipped with engine oil coolers.note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided within a reasonable time and free of charge or the remedy does not correct the defects or noncompliance, please contact saab service center at 1-800-955-9007. Also, contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
DEFECT #3 - SERVICE BRAKES, HYDRAULIC:ANTILOCK:CONTROL UNIT/MODULE
Posted on: 1995-04-04
Description
Moisture can follow the electrical harness and enter the pressure switch connector causing corrosion and malfunction of the switch.
Consequence
The corrosion causes a deterioration of the electricalswitch connection and can result in false illumination of abs and/or the brake warning lights and/or the loss of power assistance because of no hydraulic pumpoperation. Loss of power assist increases the driver's brake pedal effort required for stopping which can result in extended braking distances.
Corrective Action
Dealers will inspect the electrical connections to the abs pressure switch terminals for corrosion and install a shrink hose to the wiring harness to avoid moisture entering the connection. Pressure switches with corroded connectors will be replaced.
Notes
System: brakes; hydraulic; anti-skid system.vehicle description: passenger vehicles equipped with mk ii anti-lock braking system (abs) brakes.note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided free of charge within a reasonable time, please contact saab at 1-800-955-9007. Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
DEFECT #4 - EXTERIOR LIGHTING:BRAKE LIGHTS
Posted on: 1994-05-20
Description
One of the bulbs in each of the brake light lower outboard lamp assemblies may not have been properly wired, resulting in improper tail light illumination on brake application. This does not conform to the requirements of fmvss no 108, lamps, reflective devices, and associated equipment.
Consequence
Consequence of non-compliance: improper illumination of brake lights during brake application may not signal following drivers of the operator's intent to slow or stop and could result in a vehicle collision.
Corrective Action
Dealers will modify the brake light outboard lamp assemblies to meet fmvss requirements.
Notes
System: lighting; lamp or socket; brake lights.vehicle description: 4-door sedan passenger vehicles; cd and cde body styles. Note:if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided within a reasonable time and free of charge or the remedy does not correct the defect or noncompliance, please contact saab service center at 1-800-955-9007. Also, contact the nationalhighway traffic safety administration's auto safety hotline at 1-800-424-9393.