4 recalls found. |
DEFECT #1 - ENGINE AND ENGINE COOLING:COOLING SYSTEM
Posted on: 1998-08-14
Description
Vehicle description: passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, can result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.
Consequence
If a crack were to form or a seam were to separate in the heater core end piece, hot coolant could suddenly be expelled, increasing the risk of personal injury to a vehicle occupant.
Corrective Action
Dealers will install a new design radiator cap to control pressure and provide greater coolant overflow in the event of overheating.
Notes
Owner notification began march 31, 1999. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact bmw at 1-800-831-1117.also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
DEFECT #2 - VEHICLE SPEED CONTROL
Posted on: 1997-08-29
Description
The cruise control and throttle cables are attached to the same throttle valve actuating lever at the throttle housing. It is possible that the plastic bushing on either cable could break due to environmental influences coupled with vibration. If the bushing breaks, the outer cable housing can separate from the bushing. In this case, during application of the throttle pedal without cruise control being engaged, the outer tube could catch on the edge of the broken bushing.
Consequence
This could cause the throttle valve to remain partially open. It his were to occur, the car might not decelerate as expected increasing the risk of a vehicle crash.
Corrective Action
Dealers will install a spring steel clip on the outer tube of each cable in the area of the adjusting screw and plastic bushing. The clip is designed to prevent the outer tube from dislodging from the bushing.
Notes
Owner notification is expected to begin by the end of october 1997. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact bmw at 1-800-831-1117.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
DEFECT #3 - SERVICE BRAKES, HYDRAULIC:SWITCHES:BRAKE LIGHT
Posted on: 1996-07-08
Description
The brake light switch can fail allowing the switch to remain in the brake lights off position or in the brake lights on position.
Consequence
If this happens, the brake lights either will not operate or will be continuously on, regardless of brake pedal position. Following drivers would not be able to determine whether the vehicle is stopping, increasing the potential for a vehicle accident.
Corrective Action
Dealers will replace the existing brake light switch with a newly designed switch.
Notes
System: brakes; hydraulic; switch; brake light. Vehicle description: passenger vehicles. Owner notification: owner notification is expected to begin august 5, 1996. Note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact bmw at 1-800-831-1117. Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
DEFECT #4 - SEAT BELTS:FRONT:ANCHORAGE
Posted on: 1994-08-18
Description
In a fmvss no. 208 30 miles-per-hour compliance test, an unbelted test driver dummy's chest maximum resultant acceleration was 70.8 g's, which exceeds the maximum allowable value of 60 g's. Also, the unbelted passenger dummy's left femur maximum load was 2361 lbs, which exceeds maximum allowable value of 2250 lbs. The vehicles do not comply with fmvss no. 208, occupant crash protection.
Consequence
Consequence of non-compliance: in the event of an accident, the occupant will be subjected to an increased risk of injury.
Corrective Action
On automatic transmission models only, the dealer will replace the transmission support crossmember with a crossmember used on the manual transmission model. Also, the transmission rear bushing supports will be replaced with bushing having different performance characteristics. The steering column front support bearing at the firewall will be replaced with a modified part using a teflon inner surface and teflon spray will be applied to the column housing in the area of the bearing. A brace will be added between the knee bolster support and the steering column.
Notes
System: interior systems; passive restraints; air bag; driver; fmvss n0. 208.vehicle description: passenger cars, models 325i, 325ia, 325is, 325sa, and m3.note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided free of charge within a reasonable time or the remedy does not correct the noncompliance, please contact bmw service center at 1-800-831-1117. Also, contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.