Recalls for your 2004 Mazda Tribute

Recalls for 2004 Mazda Tribute

RSS Feed


8 recalls found.
All Mazda Recalls
Mazda Tribute DX-V6 2002

RL GNZLZ posted a photo:

Mazda Tribute DX-V6 2002

The Tribute was a rebadged version of the Ford Escape. It's rare here, it was sold only for a couple of years.

DEFECT #1 - VEHICLE SPEED CONTROL:CABLES


Posted on: 2004-12-10
Description
On certain sport utility vehicles, the accelerator cable may prevent the throttle from returning to the idle position.  

Consequence
An unexpected increase in engine idle speed may increase stopping distance and may result in a vehicle crash.  

Corrective Action
Dealers will replace the accelerator cable.  The recall began on january 28, 2005.  Owners should contact mazda at 1-800-222-5500, option #4.  

Notes
Mazda recall no.  2704l.customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

DEFECT #2 - LATCHES/LOCKS/LINKAGES:HATCHBACK/LIFTGATE:LOCK


Posted on: 2004-12-23
Description
Certain 2004-2005 sport utility vehicles and certain 2001-2003 sport utility vehicle having rear liftgate components serviced with 2004 equivalent components fail to comply with the requirements of federal motor vehicle safety standard no.  206, 'door locks and door retention components.' the rear liftgate latching system does not meet the inertia load requirement in one direction.

Consequence
If the liftgate is left unlocked, there is the potential that it may open during a crash.

Corrective Action
Dealers will replace the rear liftgate latch release rod, the release rod attachment clip and the door handle return spring.  The recall began on march 31, 2005.  Owners should contact mazda at 1-800-222-5500.

Notes
Mazda recall no.  2804l.  Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-327-4236.

DEFECT #3 - SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:MASTER CYLINDER


Posted on: 2007-03-29
Description
Certain cardone master cylinders with part numbers 10-2925, 10-2987, 10-2987mza, 10-3083, 11-3015, 11-3042, 11-3044, 11-3045, 11-3047, 11-3064, and 11-3156, and with date codes lower than dca7078 sold as replacement equipment for use on the vehicles listed above.  The seal on master cylinder can fail and leak brake fluid.

Consequence
Loss of brake fluid can result in poor braking performance, possibly resulting in a vehicle crash.

Corrective Action
Cardone will notify owners and offer to repurchase any defective master cylinders.  The recall began during april 2007.  Owners can contact cardone at 1-800-777-4780.

Notes
This recall only pertains to aftermarket cardone master cylinders and has no relation to any original equipment installed on the vehicles listed above.customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.

DEFECT #4 - SERVICE BRAKES, HYDRAULIC:ANTILOCK:CONTROL UNIT/MODULE


Posted on: 2007-04-11
Description
On certain sport utility vehicles equipped with antilock brakes (abs), the abs module connector may have missing or dislodged wire seals.  This condition could allow contamination to enter the module connector, creating a potential for an electrical short.  

Consequence
An electrical short might cause an abs malfunction that would illuminate the abs warning light, and in some cases, the module may overheat resulting in burning odor, smoke, and/or fire.  This condition could occur either when the vehicle ignition switch is in the off position or while the vehicle is being operated.  

Corrective Action
Dealers will inspect the wire harness connector to the abs module for missing or dislodged wire seals, and repair or replace the harness connector as appropriate.  The dealer will also inspect the connector on the abs module and replace it if it is found to be corroded or damaged.  The recall began on may 9, 2007.  Owners may contact mazda at 1-800-222-5500.

Notes
Mazda recall no.  4507c.customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov.

DEFECT #5 - ENGINE AND ENGINE COOLING


Posted on: 2012-07-27
Description
Mazda is recalling certain model year 2001 through 2006, and 2008, tribute vehicles equipped with 3.0l v6 engines and speed control.  Inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed.  This risk exists regardless of whether or not speed control (cruise control) is used.

Consequence
A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could cause a crash, serious injury or death.  

Corrective Action
Mazda will notify owners, and dealers will repair the vehicles by increasing the engine cover clearance, free of charge.  Remedy parts are now available.  The safety recall began on september 13, 2012.  Owners may contact mazda customer assistance center at 1-800-222-5500, option #6.

Notes
Mazda's recall campaign number is 6812g.owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.safercar.gov.

DEFECT #6 - VEHICLE SPEED CONTROL:CABLES


Posted on: 2012-07-27
Description
Mazda is recalling certain model year 2001 through 2006, and 2008, tribute vehicles equipped with 3.0l v6 engines and speed control.  Inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed.  This risk exists regardless of whether or not speed control (cruise control) is used.

Consequence
A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could cause a crash, serious injury or death.  

Corrective Action
Mazda will notify owners, and dealers will repair the vehicles by increasing the engine cover clearance, free of charge.  Remedy parts are now available.  The safety recall began on september 13, 2012.  Owners may contact mazda customer assistance center at 1-800-222-5500, option #6.

Notes
Mazda's recall campaign number is 6812g.owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.safercar.gov.

DEFECT #7 - STRUCTURE:FRAME AND MEMBERS


Posted on: 2014-04-10
Description
Mazda north american operations (mazda) is recalling certain model year 2001-2004 tribute vehicles manufactured may 22, 2000, through december 19, 2003, originally sold, or currently registered in, connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin and the district of columbia.  These vehicles may experience excessive corrosion at the forward attachment of the lower control arm.  

Consequence
A separation of the lower control arm can result in a significant loss of steering control, increasing the risk of a crash.

Corrective Action
Mazda will notify owners, and dealers will install a newly designed reinforcement cross-brace, free of charge.  The recall began on may 29, 2014.  Owners may contact mazda at 1-800-222-5500.  Mazda's number for this recall is 7514d.

Notes
Owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.safercar.gov.

DEFECT #8 - SUSPENSION:FRONT:WHEEL BEARING


Posted on: 2015-06-03
Description
The timken company (timken) is recalling certain aftermarket front wheel bearings, part number 510072, sold from january 22, 2015, to may 21, 2015, to be used as service parts on 2001-2012 ford escape, 2001-2011 mazda tribute, and 2005-2011 mercury mariner vehicles.  The affected wheel bearings have incorrect dimensions of a 42mm bore, 76mm outer dimension, and 39mm width, instead of a 42mm bore, 78mm outer dimension and a 45mm width.

Consequence
Use of an incorrectly sized wheel bearing can adversely affect the braking and steering of the vehicle, increasing the risk of a crash.

Corrective Action
Timken has begun notifying distributors who will offer purchasers replacement wheel bearings, free of charge.  The recall began on may 21, 2015.  Owners may contact timken customer service at 1-866-984-6536.  

Notes
Owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.safercar.gov.