5 recalls found. |
DEFECT #1 - STEERING:LINKAGES:ARM:IDLER AND ATTACHMENT
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that heat treat problem with certain parts of ball stud as- semblyat bottom of steering arm may not be within heat treat tolerance.failure ofthese parts could cause ball to be released from steering arm.(correct by re-placing ball stud.)
DEFECT #2 - SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DRUM
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that brake drum does not seat properly against hub.also, hub studlock groove may not be machined to proper depth.these conditions will causeflexure of drum surface when mounted to hub, and could shorten life of wheeland drum.(correct by grinding off edges between drum and hub, and re-machinegrooves to proper depth.)
DEFECT #3 - FUEL SYSTEM, GASOLINE:FUEL INJECTION SYSTEM
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that fuel rack and rack bearing on fuel injector pump housing mayfail.if this occurs, could result in over-speeding of engine.(correct byreplacing with new fuel rack and rack bearing.)
DEFECT #4 - PARKING BRAKE:DRIVELINE:AIR
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that defect may exist in air control valve that can cause leakagefrom third air tank into spring brakes after control has been applied byoperator.(correct by installing new valve.)
DEFECT #5 - POWER TRAIN
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possible misalignment of fixed arm welded to axle assembly causing axle to be located other than at center of vehicle.could cause chafing of inner dualtire, causing premature wear or tire failure.(correct by inspection and proper alignment where necessary.)