|
|
Recalls for
OEM Parts Rolls-royce Bentley
|
6 recalls found.
|
DEFECT #1 - STEERING:GEAR BOX (OTHER THAN RACK AND PINION)
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that under certain over- load conditions set screws which hold thetwo side steering levers to steering mechanism may work loose.if this occurs,continued use could cause serious steering con- trol problems.(correct by in-stalling special designed locking plate.) DEFECT #2 - SUSPENSION:FRONT:WHEEL BEARING
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that bearing pins used in the front suspension were incorrectly heated before forging, in such a way as to seriously affect the structure of the metal in the pins and to make them subject to failure under certain conditions.if one of these pins should break while the car is underway, steering control could be dangerously affected.(replace the subject pins.) DEFECT #3 - SERVICE BRAKES, HYDRAULIC:PEDALS AND LINKAGES
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility that the pins used in the brake linkage system were improperly manufactured and installed.this could allow the pins to work free, causing disconnection of the brake linkage.such a disconnection would result in total foot brake failure.(inspect and install retaining clips as required.) DEFECT #4 - POWER TRAIN:DRIVELINE
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possible failure of the rear axle pinion bearing may occur because of failure to perform an internal drilling within the axle casing to supply lubricant to the bearing.(inspect and replace axle as necessary). DEFECT #5 - VEHICLE SPEED CONTROL
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possibility of the accelerator pedal shaft rubbing the floor board, which could cause an accelerator sticking condition.(install different type lever and clamping arrangement which will rectify this condition.) DEFECT #6 - SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:CALIPER
Posted on: 1979-10-12
Description
Consequence
Corrective Action
Notes
Possible looseness of brake caliper securing set screws.if one of these is loose, there is a possibility of a wheel locking on normal braking, with consequent directional instability.(check tightness of the subject set screws.)